我家的吸尘机

Power switch

The power switch is located on the end of the curved handle.

To turn hand vacuum ON ( I ), press up.

To turn hand vacuum OFF ( 0 ), press down

Cleaning with flexible rubber contour nozzle

1. Turn hand vacuum OFF.

2. Remove hard nozzle by pressing down on

round nozzle release button.

3. Replace with flexible rubber contour nozzle by lining

up the bottom of nozzle to the bottom of the dirt

container. Pivot upwards until it snaps into place.

4. Make sure the nozzle has snapped securely

into place before using

Emptying the dirt container

Empty the dirt container after each use. A

full dirt container may reduce suction or

performance of vacuum.

1. Turn hand vacuum OFF.

2. Unplug hand vacuum from electrical outlet.

3. Press dirt container release latch down to

disconnect dirt container and filter assembly

from the unit.

4. Remove filter by grasping tabs on both sides

of filter frame and pulling away from the dirt

container. For best results, periodically tap

filter assembly against trash can to remove

dirt that has collected on the screen and

filter.

5. Empty dirt into trash can.

6. Replace filter assembly by aligning side

labeled “TOP” into top of dirt container.

Grasp filter tabs and press firmly to ensure

filter assembly is secure in dirt container.

NOT E: Make sure side of filter assembly

labeled "TO P" faces outward when inserting

filter assembly into dirt container.

7. Reattach dirt container to unit by aligning

bottom of dirt container to bottom of unit.

Pivot upwards and snap into place. Use one

hand to hold the unit and use the other hand

to clip the dirt container securely in place